Connecting Shapes - Org Chart (2007)

[damselfly]

I cannot figure out why when I click the connecting tool, and click on a
connection point of one shape, then drag to another shapes connection point,
the line doesn't connect. I can't figure this out, then when I add mulitple
shapes, the connection lines do not even come close to the shapes, they
appear at the bottom left hand corner of the screen!! Ugh...please help! I
have auto connect on and tried to check and un-check the snap and glue
options.. but nothing seems to help. I have to get this org chart done by
next week..and 2007 was just installed...
What is going on !??
Thanks!

 

[J Kallay]

Is this occurring with any particular shape, or all the time? If you're
unsure, try the following:
1)Draw to rectangles on a blank Visio drawing page using the rectangle tool
2)Add a single connection point to each rectangle. Do this by clicking the
down arrow next to the Connector Tool and change the selected tool to the
Connection Point Tool. Select the rectangle and the click somewhere within
the rectangle while holding the Ctrl key to add a connection point. Repeat
for the other rectangle.
3)Go back to the Connector Tool and try to add a connector between the two
connection points you just created. Report your findings.