Dynamic connector, fix edges

[eri]

Hi,

this is what I want.

I want to have a connector shaped as a polygonal line made out of 3 edges. The edges at the two ends are horizontal and should be fixed i.e. length and orientation should not change when I want to move one end of the connector.
Only the middle edge should change.

I try to do it with a dynamic connector, but I don't know how to set the margin edges fixed. Is this possible?

Thanks.

 

[Paul Herber]

Hi,

this is what I want.

I want to have a connector shaped as a polygonal line made out of 3 edges. The edges at the two ends are horizontal and should be fixed i.e. length and orientation should not change when I want to move one end of the connector.
Only the middle edge should change.

I try to do it with a dynamic connector, but I don't know how to set the margin edges fixed. Is this possible?

Thanks.

These newsgroups are no longer in use and it is unlikely that you will get an answer here.
There are replacement forums for Visio, Microsoft's own:
http://social.technet.microsoft.com/Forums/en-US/visiogeneral/threads
http://answers.microsoft.com/en-us/office/forum/visio?page=1&tab=all

or Visio MVP VisioGuy
http://www.visguy.com/vgforum/



--
Regards, Paul Herber, Sandrila Ltd.
Electronics for Visio http://www.sandrila.co.uk/visio-electronics/
Electrical for Visio http://www.sandrila.co.uk/visio-electrical/
Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/
TTL for Visio http://www.sandrila.co.uk/visio-ttl/
CMOS for Visio http://www.sandrila.co.uk/visio-cmos/