T
terri
I have a report that uses Line commands in the Print event. The report
contains a subreport that also contains Line commands. Some sections of the
subreport print conditionally. When a section is skipped, I get a blank page
at the end of the report. Removing the code in the sub’s Print events
corrects the issue.
Any ideas why this would happen? I would much rather control the lines
directly.
Thanks!
contains a subreport that also contains Line commands. Some sections of the
subreport print conditionally. When a section is skipped, I get a blank page
at the end of the report. Removing the code in the sub’s Print events
corrects the issue.
Any ideas why this would happen? I would much rather control the lines
directly.
Thanks!