N
Nigelb
Groove is not synchronizing after upgrade to final version. I even
uninstalled and reinstalled. The communications manager says it's
communicating normally but nothing is being synchronized. The only way to
force a synchronization is to shut down and restart groove on both machines
(i'm only trying to sync two machines). Then it works - for that one time.
Any changes made after restart fails to synchronize until both grooves are
shutdown and restarted. I tried creating a new workspace to see if that
would sync but no dice.
Any ideas on what I should look at? It's not like there are a lot fo
options inside of groove itself.
Thanks in advance for any help.
uninstalled and reinstalled. The communications manager says it's
communicating normally but nothing is being synchronized. The only way to
force a synchronization is to shut down and restart groove on both machines
(i'm only trying to sync two machines). Then it works - for that one time.
Any changes made after restart fails to synchronize until both grooves are
shutdown and restarted. I tried creating a new workspace to see if that
would sync but no dice.
Any ideas on what I should look at? It's not like there are a lot fo
options inside of groove itself.
Thanks in advance for any help.