Different units on same axis in diagram

[Rocky]

Different units on same axis in diagram (for example Nm and Lbin on X and MPa and PSI on Y)

 

[Bernard Liengme]

Make a second data set: x-values in Lb/in2 , same y-values
Add this to same chart
Second series- specify second x-axis; label if pounds/sq in

--
Bernard Liengme
www.stfx.ca/people/bliengme
remove CAPS in e-mail address

Different units on same axis in diagram (for example Nm and Lbin on X and

MPa and PSI on Y)

 

[Bernard Liengme]

You can always hide one line by specifying No Markers & No Line

--
Bernard Liengme
www.stfx.ca/people/bliengme
remove CAPS in e-mail address

I still get two lines.
What I want to do is:
one line in the diagram (Torque-pressure comparison)
We make diagrams that shows what pressure compares to what torque they get on our products
Depending on country we sell to the diagram must show different units.
Therefore I need 2 y-axis with pressure (MPa on left side or PSI on rigth

side) comparing to Torque on 2 X-axis (Nm on lower axis and lbin on upper
axis)