Move a page position

[FrankDe]

I am new at Publisher so forgive me. I am writing a photo documentary. My
pictures on Publisher have had to be broken up into sets of 101 due to size.
When I open one of the volumes (Publisher Documents) to edit the photos, I
notice that the page is located at the 0" X axis but at the 1.875" Y axis.
This means when I try to place the photo at 0" X and 0" Y, it is 1.875 inches
too high according to the page location.

How do I adjust the location of the page in accordance with the X and Y
Axis? I use Windows Publisher 2007.

Thank you

 

[Mary Sauer]

When I position an image at horizontal 0" and vertical 0" from Top Left Corner,
it is exactly where I positioned it. Do you have a wrap involved. Are you
certain you have your printer setup correctly. Maybe I'm dense, but I don't know
what you are trying to do.

 

[FrankDe]

 
Mary,
First of all I am grateful for your reply. Here is my dilemma: I am writing
a book consisting of 550 or so 2 mb images. I am only able to work with
about 101 before publisher becomes sluggish and locks up. As a work around, I
am writing the book in 5 volumes and then I will have my publisher put it all
together 1 volume at a time.

4 of my 5 volumes, (Separate Publisher Documents) are all correct with a 0â€
X and a 0†Y.

One rouge document has a X of 1.875†and I do not know how to get it back to
zero.

When I zero the picture, it ends up being 1.875 inches too high on the page.
I am trying to figure out how to get the page back up to zero X Zero Y. I
am at a loss for what the heck I did to get it to this to begin with but I am
hoping I will be able to figure it out instead of having to do the entire 101
images over.
Thanks
Frank

 

[Mary Sauer]

Have you tried to re-change the page setup? Maybe it has lost its focus. I've
never seen this, nor can I find any Knowledge Base articles that addresses the
issue.

Do you have a border on the pages? What about the images, do they have
transparency that is extending beyond the page borders.

Do you have a page bleed enabled in your print setup? Is a different printer
setup than the other documents? Is this particular document setup for
centimeters?

I'm grasping at straws here.

 

[FrankDe]

Once again, thank you for the response.

Sad to say:
Changed Page set-up 3 times no luck.
No bleed enabled
No printer at all set up for any of the programs since I do not print
Not in centimeters
And I have decided I am simply going to have to do it all over again!
If you figure it out, I will be happy to know.

Thank you
Frank

 

[Mary Sauer]

Frank, Select a default printer, even a generic printer will do. It might make a
difference.

 

[FrankDe]

A valiant try but no luck.

Frank, Select a default printer, even a generic printer will do. It might make a
difference.

--
Mary Sauer MSFT MVP
http://office.microsoft.com/
http://msauer.mvps.org/
news://msnews.microsoft.com

 

[Ed Bennett]

A valiant try but no luck.

This is a really intriguing issue - can you email me the file

the UNDERSCORE nerd AT mvps DOT org

and I'll have a gander at it.