N
Nathan
In Access 2000 I created several reports that have printer magins set to 0.5
Right 0.5 left 0.5 top and bottom. and the reports printed fine on one page.
After upgrading to Office 2003. The left margin will not say at 0.5 it will
automatically go to 0.616. I've tried reseting the page setup on the
reports. and in the options tools menu. no luck it just goes right back to
0.616. I had also created publisher doc's with the same margins and after
the upgrade the same thing happens. So it's an office issue that I'm having.
I checked for new printer drivers and the drivers are current. The printer
is a HP Deskjet 2500c.
Is there a way I can get my the left margin to go lower then 0.616 either by
registry or in software? or did Microsoft add a "buffer" and I will have to
go through my reports and docs and configure them for the new margin
requirements.
Thanks In Advance for your Input
P.S. I did try a HP laserjet and had NO ISSUES. with the left margin @
0.5., but not the printer I would like it to work on (the deskjet)
Right 0.5 left 0.5 top and bottom. and the reports printed fine on one page.
After upgrading to Office 2003. The left margin will not say at 0.5 it will
automatically go to 0.616. I've tried reseting the page setup on the
reports. and in the options tools menu. no luck it just goes right back to
0.616. I had also created publisher doc's with the same margins and after
the upgrade the same thing happens. So it's an office issue that I'm having.
I checked for new printer drivers and the drivers are current. The printer
is a HP Deskjet 2500c.
Is there a way I can get my the left margin to go lower then 0.616 either by
registry or in software? or did Microsoft add a "buffer" and I will have to
go through my reports and docs and configure them for the new margin
requirements.
Thanks In Advance for your Input
P.S. I did try a HP laserjet and had NO ISSUES. with the left margin @
0.5., but not the printer I would like it to work on (the deskjet)