C
Chip
Hi!
I am having a problem with using a button on one form (form1) to open
another form (form2). The problem is that when the button is pressed the
Form2 that is opened in a "Full Screen" mode instead of with the "thin"
border that it is set up to open with. Also, if i minimize the form2 then
maximize it the form shows as it should with a 'thin' border and not in the
"full screen" mode as it was originally opened. If i open the form2 by
itself it opens coorectly. I have checked everything i know of but the
Form1 where i put the button was not built by me and i am new with ACCESS so
there may be setting i do not know about. Also, i created the button using
the ACCESS button Wizard...
Can anyone offer some help on this????
And as always, THANKS IN ADVANCE!!!!
I am having a problem with using a button on one form (form1) to open
another form (form2). The problem is that when the button is pressed the
Form2 that is opened in a "Full Screen" mode instead of with the "thin"
border that it is set up to open with. Also, if i minimize the form2 then
maximize it the form shows as it should with a 'thin' border and not in the
"full screen" mode as it was originally opened. If i open the form2 by
itself it opens coorectly. I have checked everything i know of but the
Form1 where i put the button was not built by me and i am new with ACCESS so
there may be setting i do not know about. Also, i created the button using
the ACCESS button Wizard...
Can anyone offer some help on this????
And as always, THANKS IN ADVANCE!!!!