W
widman
I have a graph set up where an input starts the range you want to look at. I
always want the "Y" to start at 0, and the scale nicely goes as high as
necesary for the numbers in the table (viscosity). If I want to look at the
100 degree temperature range starting at 0, the x axis works fine. but if I
choose to look at 50 and above, the "x" axis still starts with 0, leaving a
blank graph between 0 and 50 and still stopping at 100.
How can I set it so the x axis scale starts at the value selected?
always want the "Y" to start at 0, and the scale nicely goes as high as
necesary for the numbers in the table (viscosity). If I want to look at the
100 degree temperature range starting at 0, the x axis works fine. but if I
choose to look at 50 and above, the "x" axis still starts with 0, leaving a
blank graph between 0 and 50 and still stopping at 100.
How can I set it so the x axis scale starts at the value selected?