P
Patrick
I am using Visio 2000. I am drawing an office layout, with tables, chairs,
walls, etc. Should be easy right? Well in general it is, but as I was trying
to size items to specific feet and inch measurements, I noticed that when I
zoom in to 400%, each foot on the ruler is divided into 10 units instead of
12 inches. This is enourmously frustrating. Is there a way to get Visio to
use a snap-to grid that divides each foot into 12 inches?
I have the default units in the Regional Settings set to Feet and Inches,
but I have also tried "Inches", "Inches(decimal)", and "Feet(decimal)". None
have worked.
Thanks for any help you can provide.
walls, etc. Should be easy right? Well in general it is, but as I was trying
to size items to specific feet and inch measurements, I noticed that when I
zoom in to 400%, each foot on the ruler is divided into 10 units instead of
12 inches. This is enourmously frustrating. Is there a way to get Visio to
use a snap-to grid that divides each foot into 12 inches?
I have the default units in the Regional Settings set to Feet and Inches,
but I have also tried "Inches", "Inches(decimal)", and "Feet(decimal)". None
have worked.
Thanks for any help you can provide.