J
jutlaux
I have a AutoKeys macro setup that currently has 1 line in to do a
Ctrl+Shift+C key stoke. I would like to be able to also capture when the
enter key is pressed and based on the SendKeys help this should be
accomplished by putting {ENTER} OR {~} in the Macro Name column. When I goto
save the Macro with either one of these in their I get the following error:
"The key or key combination {~} in AutoKeys has invalid syntax or is not
allowed.
Use the SendKeys syntax to specify the key or key combinations.
For the allowed key or key combinations, click Help."
in the above error substitute {ENTER} for {~} when i try that and I get the
same message.
I have tried all the following, but still have had no luck:
{ENTER}
ENTER
(ENTER)
{~}
~
(~)
What am I doing wrong?
Thanks,
Ctrl+Shift+C key stoke. I would like to be able to also capture when the
enter key is pressed and based on the SendKeys help this should be
accomplished by putting {ENTER} OR {~} in the Macro Name column. When I goto
save the Macro with either one of these in their I get the following error:
"The key or key combination {~} in AutoKeys has invalid syntax or is not
allowed.
Use the SendKeys syntax to specify the key or key combinations.
For the allowed key or key combinations, click Help."
in the above error substitute {ENTER} for {~} when i try that and I get the
same message.
I have tried all the following, but still have had no luck:
{ENTER}
ENTER
(ENTER)
{~}
~
(~)
What am I doing wrong?
Thanks,