T
Turk
When I make a page that has (table around 650 pixels) one or two cells on the
right hand side (around 250pixles wide) and then a colum of cells down the
left (around 250) and then preview the page, the cells on the right srink so
they look like there only 100 pixels wide while the ones on the left get
wider. No matter what I do I can't correct it and usually have to scrape the
page and start again.
This happens every so often, I'm not sure if your only supposed to have a
certain amount of cells in a table or weather it's a bug. Some pages I make
this way work fine.
It only seems to happen when I have cells in two colums beside each other,
when I move the cells around so there not next to each other they go back to
the sizes I gave them, but the problem returns if I move them back.
Is it a bug or should I be doing something to avoid this happening?
right hand side (around 250pixles wide) and then a colum of cells down the
left (around 250) and then preview the page, the cells on the right srink so
they look like there only 100 pixels wide while the ones on the left get
wider. No matter what I do I can't correct it and usually have to scrape the
page and start again.
This happens every so often, I'm not sure if your only supposed to have a
certain amount of cells in a table or weather it's a bug. Some pages I make
this way work fine.
It only seems to happen when I have cells in two colums beside each other,
when I move the cells around so there not next to each other they go back to
the sizes I gave them, but the problem returns if I move them back.
Is it a bug or should I be doing something to avoid this happening?