V
Vel.
Hello,
I was wondering if there was a way to force a subreport to break into two
columns at page break in the same way it would if it was not a subreport. I
did some searching, and found that the general answer to my question was to
go 'across, then down'. Unfortunately, this solution makes nice formatting
difficult, particularly as it pertains to section headers for identifying
fields. It also is likely to cause confusion on the user end, since most
people are used to reading columns down, then across. Any suggestions? Is
there any way to do this?
Vel
I was wondering if there was a way to force a subreport to break into two
columns at page break in the same way it would if it was not a subreport. I
did some searching, and found that the general answer to my question was to
go 'across, then down'. Unfortunately, this solution makes nice formatting
difficult, particularly as it pertains to section headers for identifying
fields. It also is likely to cause confusion on the user end, since most
people are used to reading columns down, then across. Any suggestions? Is
there any way to do this?
Vel