K
Kim
I have a spreadsheet with several columns of information. Two of those
columns will not allow the user to activate any of its cells. When the user
attempts to click on a cell in one of the two columns, the spreadsheets jumps
to a different location and randomly activates a different cell. I also
cannot isolate selection the entire column by clicking on the column letter
at the top. I can however, use ctrl+click to select the two problem columns
(I must begin with an active cell outside of the problem columns). Any
suggestions as to what is causing this behavior?
FYI: I can copy the entire worksheet and paste the information into a
different spreadsheet and the problem columns work properly.
Thank you for your feedback.
columns will not allow the user to activate any of its cells. When the user
attempts to click on a cell in one of the two columns, the spreadsheets jumps
to a different location and randomly activates a different cell. I also
cannot isolate selection the entire column by clicking on the column letter
at the top. I can however, use ctrl+click to select the two problem columns
(I must begin with an active cell outside of the problem columns). Any
suggestions as to what is causing this behavior?
FYI: I can copy the entire worksheet and paste the information into a
different spreadsheet and the problem columns work properly.
Thank you for your feedback.