is it possible to place an arrow in the centre of a connector as well as the beginning or end?
T The Rook Oct 19, 2009 #1 is it possible to place an arrow in the centre of a connector as well as the beginning or end?
W WapperDude Oct 19, 2009 #2 Yes, it can be done. You need to create a custom line pattern. See this article by Visio Guy: http://www.visguy.com/2008/03/03/release-the-power-of-visio-custom-line-patterns/. The article makes reference to two articles by John Goldsmith. These are a must to read. HTH Wapperdude.
Yes, it can be done. You need to create a custom line pattern. See this article by Visio Guy: http://www.visguy.com/2008/03/03/release-the-power-of-visio-custom-line-patterns/. The article makes reference to two articles by John Goldsmith. These are a must to read. HTH Wapperdude.
