controls and macros

C

cecilia12345

i want to asign a macro to a button (commmand button) and i drew on
using the controls toolbox. anyways, this is not working for me
aparently i should do it in a different way but how?
i`ve been reading that there are too kinds of buttons but i think i
using the wrong ones...
 
B

Bob Phillips

Cecilia,

If you use controls toolbox buttons, you don't assign a macro to it, you use
its click event.

To do this, in design mode (the blue triangle in the toolbar) double-click
the button and this takes you to the code input screen.

--

HTH

Bob Phillips
... looking out across Poole Harbour to the Purbecks
(remove nothere from the email address if mailing direct)
 
R

Robin Hammond

Sounds like you are using the controls toolbox rather than the forms
toolbox.

The controls version will allow you to create a sub linked to the control.

If you have a pre-existing macro you want to link, use the forms toolbox,
then right click on the button and assign a macro.


Robin Hammond
www.enhanceddatasystems.com
 
Top