Creating shapes.

[Matt Carter]

I posted below
http://www.microsoft.com/communitie...18e3&mid=7847738b-cc6c-460f-9433-7115b6e818e3

That I was looking for a laptop Port Replicator to be used in Visio 2003. I
find that no one has a possible answer. I ask again, in another fashion, if
there is a way to create a shape without having extensive drawing
capabilities, etc.

Thank you.

 

[Al Edlund]

the quality of the picture of course is relative to the author and the
viewer. have you checked the vendor site for the replicator to see if they
have stencils? another choice might be to just create what your are looking
for from existing sub components (a nine pin d-shell is the same wherever
you get it, as well as rj-45 jacks and power plugs). seimons and other
vendors supply those in bulk. I believe you can get some pointers from John
Marshall's site (www.mvps.org)
al

 

[Matt Carter]

Thank you Al, I went to http://www.visiocafe.com/hp.htm and
http://www.visiocafe.com/ibm.htm to get both stencils for our workstations
and desktops and monitors and misc. items. THANK YOU!
I wasn't sure using visiocafe.com however I did a search on IBM and they said:
http://www-128.ibm.com/developerworks/forums/dw_thread.jsp?forum=375&thread=100755&cat=5

That VisioCafe.com had their OFFICIAL stencils. I was happy to find that
out!

Thank you again!

Matt