C
Cindy
Hi all - this has been bugging me for a few days.
I have created two new Custom Property Sets - one containing power
information (voltage, faceplate finish, # gang switches) and a second one
which contain cost/pricing information.
I select the layer I want to assign the properties, in my case the
electrical fixtures layer.
I APPLY the two new sets to the selected objects.
All looks ok so I enter some data.
I save my document.
I re-open my document.
Only some of the data has been saved, and there is no discernable pattern as
to what is/isn't saved.
Combine this with the fact that sometimes the custom properties window does
not show my new Custom Property Sets, unless I go into the set, open it up,
then simply click OK, and the custom properties window is then refreshed.
Installation is Visio 2003 Standard SR2.
Thanks in advance, Cindy
I have created two new Custom Property Sets - one containing power
information (voltage, faceplate finish, # gang switches) and a second one
which contain cost/pricing information.
I select the layer I want to assign the properties, in my case the
electrical fixtures layer.
I APPLY the two new sets to the selected objects.
All looks ok so I enter some data.
I save my document.
I re-open my document.
Only some of the data has been saved, and there is no discernable pattern as
to what is/isn't saved.
Combine this with the fact that sometimes the custom properties window does
not show my new Custom Property Sets, unless I go into the set, open it up,
then simply click OK, and the custom properties window is then refreshed.
Installation is Visio 2003 Standard SR2.
Thanks in advance, Cindy