Design Mode

J

Juran

A long time ago, I created a database for my work, since
then I barely created another database.

When I finish the database, I pressed a key that would not
allow any one to go to the design mode. Now I new to
perform same changes to this database and I do not remember
which key I should press to allow me into the design mode.

Any suggestion?

Thank you.

Juran
 
6

'69 Camaro

Hi, Juran.

If I understand your situation correctly, then all you need to do to bypass
the startup settings to work on your database application is to hold down
the <SHIFT> key while opening the database and keep holding it down until
the database is completely open.

HTH.

Gunny

See http://www.QBuilt.com for all your database needs.
See http://www.Access.QBuilt.com for Microsoft Access tips.

(Please remove ZERO_SPAM from my reply E-mail address, so that a message
will be forwarded to me.)
 
J

Juran

Joseph,

Thank tou.

Juran
-----Original Message-----


With luck you did as '69 suggested and his instructions will work fine.

There are two other ways that I can think of that might be involved.
You might have made it a mde file rather than a mdb file. If so you will
need to find the original file and import the data from the mde. You may
also have secured it with a password, there are a couple of possibilities
there so if that is the case let us know.

--
Joseph Meehan

26 + 6 = 1 It's Irish Math


.
Click to expand...
 
G

Guest

69 Camaro,

Thank you.

Juran
-----Original Message-----
Hi, Juran.

If I understand your situation correctly, then all you need to do to bypass
the startup settings to work on your database application is to hold down
the <SHIFT> key while opening the database and keep holding it down until
the database is completely open.

HTH.

Gunny

See http://www.QBuilt.com for all your database needs.
See http://www.Access.QBuilt.com for Microsoft Access tips.

(Please remove ZERO_SPAM from my reply E-mail address, so that a message
will be forwarded to me.)





.
Click to expand...
 
Top