Document Imaging 2007 scans only one page

[Scott]

I have scanned 50 page documents with no problem on my XP machine using
Office 2003. I use an Epson CX11NF All in one with an auto document feeder
and it has worked flawlessly. Now I have MS Office PRo 2007 on Vista
Business. The document feeder stops after the first page. The dialog box
says that the scanner is finished. If I click continue, it will scan the
next page and then say finished. I scan double sided documents (I flip the
paper over and scan side two) so MS Scan and Fax will not work because the
paper will be out of sequence. Does anyone know of an issue with Office 2007
MDI that would make my auto document feeder stop after the first page? I
know that it is not my scanner because I hooked it back up to my old machine
(XP w/office 2003) and it worked fine. ANy help would be appreciated.

 

[rustywissmiller]

Have you told MDI that you are using a auto document feeder? If you click to
scan a new document, it brings up a box, in the middle right there is a
scanner... button. if you click that it gives you the option not only choose
your scanner, but also to use an document feeder. don't know if that's the
problem, but I wish you luck.

 

[Scott]

Thanks, Rusty, but I have notified it that I am using an ADF. IT's the same
setup as before, just using Vista with Office 2007 instead of XP with 2003.
I have tried detect and Repair, loaded drivers from the Epson website, etc.
I noticed a few other posts concerning this, but not many resolutions. I
wonder if this is a really bad problem. I really need this. POssibly do you
have any other thoughts? Thanks again,
Scott