A
Anne
I have a report, which has maximum data 8 columns and 6 row.
The report detail shows as a little block of data about 1 1/4 inch high and
wide which hold data for 14 fields. Everything works just fine as long as
there is data.
The row represents a 6 gangs (GangID) and the columns are joists Data .
I would like the entire page to fill with these blocks, even if there is no
data.
I am presently using Duane Hookom's routine to draw squares with code, but
it does not look right,
I hope there is some code that could repeat the present layout rather than
just lines.
Anne
The report detail shows as a little block of data about 1 1/4 inch high and
wide which hold data for 14 fields. Everything works just fine as long as
there is data.
The row represents a 6 gangs (GangID) and the columns are joists Data .
I would like the entire page to fill with these blocks, even if there is no
data.
I am presently using Duane Hookom's routine to draw squares with code, but
it does not look right,
I hope there is some code that could repeat the present layout rather than
just lines.
Anne