I
Idaho Word Man
I often use PP to create flow charts that I eventually paste into Word
documents. Usually it works very well, but today I have a flow chart where
one line has to cross two others to reach its destination. (I've tried
rearranging the chart to avoid crossing, but it won't work.)
The engineer who requested the flow chart gave me his hand drawn original
with little "bumps" in the line that crossed that made it clear that it was
to cross, rather than connect. Is it possible to make a connector behave that
way in PP? If so, how? Is there any solution other than drawing partial lines
and little half-circles?
Thanks,
Fred
documents. Usually it works very well, but today I have a flow chart where
one line has to cross two others to reach its destination. (I've tried
rearranging the chart to avoid crossing, but it won't work.)
The engineer who requested the flow chart gave me his hand drawn original
with little "bumps" in the line that crossed that made it clear that it was
to cross, rather than connect. Is it possible to make a connector behave that
way in PP? If so, how? Is there any solution other than drawing partial lines
and little half-circles?
Thanks,
Fred