K
Kristian Tylvad
Hi
I'm not if this is the right place to post this issue, but here we go:
I have a database application, which when prompted prints out a detail
section of a form. This has been working nicely in access 2000, in which the
application has been developed. Now I have installed access 2003, and
suddenly an empty blank page is printed before the actual page. In the
design view under page setup I can see that the paper size is "Letter" - In
access 2000, however, the paper size was set to "A4". I can't change the
setting - it always reverts to "Letter". I think that it is this problem
that causes the blank page to be printed.
Any solutions will be appreciated.
Regards
--
__________________________________________________
Kristian Ravn Tylvad, Chefudvikler
Solid Software Development, Bævervej 8, 9230 Svenstrup
Tlf: 70 23 20 40 Mobil: 26 17 88 52
__________________________________________________
I'm not if this is the right place to post this issue, but here we go:
I have a database application, which when prompted prints out a detail
section of a form. This has been working nicely in access 2000, in which the
application has been developed. Now I have installed access 2003, and
suddenly an empty blank page is printed before the actual page. In the
design view under page setup I can see that the paper size is "Letter" - In
access 2000, however, the paper size was set to "A4". I can't change the
setting - it always reverts to "Letter". I think that it is this problem
that causes the blank page to be printed.
Any solutions will be appreciated.
Regards
--
__________________________________________________
Kristian Ravn Tylvad, Chefudvikler
Solid Software Development, Bævervej 8, 9230 Svenstrup
Tlf: 70 23 20 40 Mobil: 26 17 88 52
__________________________________________________