FRONTPG.EXE - Entry Point Not Found

[Thomas]

FRONTPG.EXE - Entry Point Not Found

[ The procedure entry point ?
CDC_LOCATION_STSURL@CUDCDoc@DDW@@2QBGB could not be
located in the dynamic link library fpcutl.dll ]

I have installed and uninstalled FP2003 several times. I
even tried to reload FP 2002, which was our version, but
no luck there either. I need help correcting this
problem so I can get back to working on our websites.

 

[Stefan B Rusynko]

Did you verify your system meets the minimum requirements for the BETA?

Which version of the BETA are you installing and from where



| FRONTPG.EXE - Entry Point Not Found
|
| [ The procedure entry point ?
| CDC_LOCATION_STSURL@CUDCDoc@DDW@@2QBGB could not be
| located in the dynamic link library fpcutl.dll ]
|
| I have installed and uninstalled FP2003 several times. I
| even tried to reload FP 2002, which was our version, but
| no luck there either. I need help correcting this
| problem so I can get back to working on our websites.
|

 

[Tom Miller]

I am speculating here, but possibly, when you first installed the FP2003
Beta, it replaced the "fpcutl.dll" with a different one. And when you tried
to re-install FP2002 you didn't get the older "fpcutl.dll" back. Just a
shot in the dark...
Tom

"> FRONTPG.EXE - Entry Point Not Found

 

[Dean]

I was having the same problem. I checked the setup.htm in the root of
my CD drive. I used the command "D:\Setup.exe /fa fp11.msi" to get
FrontPage to work. One of the original files must have been farkled.