getting blank pages on my report

L

LisaK

I have a blank page between each page in my report. I have looked and do not
see anything that would be making this blank page print. It does not appear
that anything is outside of the margins. I've trived moving the side bar and
it keeps going back to 9". I don't know what else to do.

Any suggestions?
 
R

Rick B

If it keeps going back to 9", then there is some control there that is
forcing it to that. You can't make the page narrower than any controls on
it.

You must have a line or a hidden control there. drag your pointer (with the
mouse button down) all over that inch and see what highlights.
 
B

Bob Miller

I've run in to this many times and it is usually the report width is
bigger than the margins set. Either pull the right side of the report
in in design view or increase the margins in File, Page Setup.
 
L

LisaK

I did what you said and I was able to change it. However, now I am getting
an error message that says my section width is wider than the report width.
What does this mean?
 
Top