how do i ungroup an autocad drawing copied into word 2003?

[jim]

Using an earlier version of Word I could copy and past an AutoCAD drawing
into Word as a Word document. I could then ungroup it and change the line
width for all lines. Next I regrouped it to have a good graphic in the Word
document. With Word 2003 I have not been able to do this. Is there a way to
do it?

 

[Cindy M -WordMVP-]

Hi =?Utf-8?B?amlt?=,

Using an earlier version of Word I could copy and past an AutoCAD drawing
into Word as a Word document. I could then ungroup it and change the line
width for all lines. Next I regrouped it to have a good graphic in the Word
document. With Word 2003 I have not been able to do this.

There's a command named "Disassemble picture" in Tools/Customize/Commands,
under the Drawing category. See if that's what you're looking for?

Cindy Meister
INTER-Solutions, Switzerland
http://homepage.swissonline.ch/cindymeister (last update Jun 8 2004)
http://www.word.mvps.org

This reply is posted in the Newsgroup; please post any follow question or
reply in the newsgroup and not by e-mail