T
Tyrone Lopez
Help! I created a simple macro to launch a pivot table covering dat
with fields as follows:
Date Units Amount
I created a pivot table manually and the results was correct. Created
macro with the same instructions, tested it and it worked. However late
with a longer list of data the macro did not provide a correct answer a
compared to a manually created pivot table.
Any clue as to the problem? Does a pivot table created through a macr
'retain' the data range and therefore gives an incorrect result if th
data range is longer than the original
with fields as follows:
Date Units Amount
I created a pivot table manually and the results was correct. Created
macro with the same instructions, tested it and it worked. However late
with a longer list of data the macro did not provide a correct answer a
compared to a manually created pivot table.
Any clue as to the problem? Does a pivot table created through a macr
'retain' the data range and therefore gives an incorrect result if th
data range is longer than the original