line bump

[Stacy]

I've Visio 2003, drawing crossing lines on my page but, they are not showing
the bump. I reviewed the layout/routing but, can't seem to figure out how to
turn on the line bump. I want to ensure that my lines bump when they cross.
Additionally, I tried selecting the line and changing it's
behavior....heeeeellllppp!

 

[Paul Herber]

I've Visio 2003, drawing crossing lines on my page but, they are not showing
the bump. I reviewed the layout/routing but, can't seem to figure out how to
turn on the line bump. I want to ensure that my lines bump when they cross.
Additionally, I tried selecting the line and changing it's
behavior....heeeeellllppp!

menu File -> Page Setup -> Layout and Routing -> Line Jumps

line jump style - Arc

 

[Mark Nelson [MS]]

Also make sure you are drawing with the Connector Tool and not the Line
Tool. Only connectors can have line jumps.

--
Mark Nelson
Office Graphics - Visio
Microsoft Corporation

This posting is provided "AS IS" with no warranties, and confers no rights.

 

[Paddy]

I've Visio 2003, drawing crossing lines on my page but, they are not
showing
the bump. I reviewed the layout/routing but, can't seem to figure out how
to
turn on the line bump. I want to ensure that my lines bump when they
cross.
Additionally, I tried selecting the line and changing it's
behavior....heeeeellllppp!

Curious. Humping cross-over lines haven't been used in International
Electrotechnical Commission standards nor Australian Standards for decades -
when I was a student (I'm 66) we were told they were no longer used.

I sometimes see schematics drawn with the old-fashioned humpy loopy
cross-overs and wondered where they come from.

Paddy

 

[christine grenier]

Hi,
You're doing everything right as long as you have Show Line Jumps selected from the Design Tab > Layout Group > Connectors; and you have arc selected from Shift-F5 > Layout and Routing. The only caveat is that this feature only works when you use Connectors (it will not work with ordinary lines).
I hope this helps?

Christine

I've Visio 2003, drawing crossing lines on my page but, they are not showing
the bump. I reviewed the layout/routing but, can't seem to figure out how to
turn on the line bump. I want to ensure that my lines bump when they cross.
Additionally, I tried selecting the line and changing it's
behavior....heeeeellllppp!

On Monday, February 26, 2007 12:33 PM Paul Herber wrote:
menu File -> Page Setup -> Layout and Routing -> Line Jumps

line jump style - Arc

On Tuesday, February 27, 2007 1:22 AM Mark Nelson [MS] wrote:
Also make sure you are drawing with the Connector Tool and not the Line
Tool. Only connectors can have line jumps.

--
Mark Nelson
Office Graphics - Visio
Microsoft Corporation

This posting is provided "AS IS" with no warranties, and confers no rights.

news:[email protected]...