Multi-Condition Formula

M

Malcolm

I’m using this formula;
=IF(OR(‘Source Sheet’!C10={“â€,â€Câ€, “Bâ€}),’Source Sheet’!B10).
This allows what I enter into the source sheet to also enter into the
destination sheet unless, “C†or “B†are present and then nothing is entered
into the destination sheet. This only leaves two conditions that would allow
data entered into the source sheet to appear in the destination sheet. These
conditions are “S†and “Dâ€. If “S†I would like to have any number entered in
the source sheet to appear in the destination sheet, but if the “D†condition
is entered in the source sheet, I would like the number 2 and only 2 to be
entered in the destination sheet. So, if I have not confused this too much,
my question is; is it possible to keep the initial two false conditions; “Câ€
and “B†in the formula and add the two true conditions “S†and “Dâ€. I hope
that my explanation is not too confusing. I don’t have a good record of being
either clear or concise.
Thank you,
Malcolm
 
B

Bob Phillips

Do you mean

=IF(OR('Source Sheet'!C10={"","C","B"}),'Source Sheet'!B10,IF(OR('Source
Sheet'!C10={"","D","S"}),2,""))
 
J

Jacob Skaria

Try

=IF(OR(C10={"","C","B"}),B10,IF(ISNUMBER(B10),IF(C10="S",B10,
IF(AND(C10="D",B10=2),2,"")),""))
 
M

Malcolm

Jacob, Hi,
I entered your formula and it worked except for the last condition “Dâ€. I
was not clear, but if the source sheet (End Bal) in cell C10 is “D†there is
no number in the source sheet (End Bal )C10. That is why I wanted to add the
2 to the destination sheet B10. So, does the “'End Bal'!B10=2) refer to the
source sheet? If so, there is no number there. If I am unclear please let me
know.

=IF(OR('End Bal'!C10={"","C","B"}),'End Bal'!B10,IF(ISNUMBER('End
Bal'!B10),IF('End Bal'!C10="S",'End Bal'!B10,IF(AND('End Bal'!C10="D",'End
Bal'!B10=2),2,"")),""))

Regards,
Malcolm
 
J

Jacob Skaria

Hi Malcolm

From your statement "I would like the number 2 and only 2 to be entered in
the destination sheet." I thought the source sheet will have the value; but
you need that to be returned only if the value is 2...

If that is not the case; then try the below version

=IF(OR('End Bal'!C10={"","C","B"}),'End Bal'!B10,
IF(ISNUMBER('End Bal'!B10),IF('End Bal'!C10="S",'End al'!B10,
IF('End Bal'!C10="D",2,"")),""))
 
M

Malcolm

Jacob, Hi,
My bad again. 'End Bal!'C10="D", 'End Bal'!B10 is an empty cell on the
source sheet. I want 'Close Bal'!C10="D" and 'Close Bal'B10=2 on the
destination sheet. Again my screwup led to to a formula based on my bad
information, my apologies.

Best Regards,
Malcolm
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top