M
Michael G. Schneider
There is an Access 2000 ADP database. Design mode is not available. Reports,
Forms, ... cannot be modified.
A report obviously has been design with a certain default printer. However,
the printer does no longer exist. If the report is started, a dialog "this
report has been formatted for printer P1, but the printer is not available.
Do you want to use printer P2 instead?" appears. If choosing yes, the report
is performed correctly. However, if later the same report is executed again,
the message appears again.
What can be done?
Michael G. Schneider
Forms, ... cannot be modified.
A report obviously has been design with a certain default printer. However,
the printer does no longer exist. If the report is started, a dialog "this
report has been formatted for printer P1, but the printer is not available.
Do you want to use printer P2 instead?" appears. If choosing yes, the report
is performed correctly. However, if later the same report is executed again,
the message appears again.
What can be done?
Michael G. Schneider