Nothing happens when I run code with breakpoint

[vegathena]

I don't know what happened to my breakpoint functionality. I used to
put a breakpoint and then run my code and then I was able to use the
debugging functions step into, over, and out.

Now nothing happens when I put a breakpoint and then try to execute my
code, i.e. clicking a cmd control that would cause the code to be
executed. I have tried different forms in different access frontends.

Does anybody have an idea what could cause this? Is there a special
setting I should look into? I am quite baffled about what could have
happened to lose this functionality.

Thanks in advance for your help.

 

[vegathena]

Ok, I found the answer:
http://www.vb-helper.com/tip_debug_access.html

 

[George Nicholson]

You would also have found the same answer if you had searched the Access
newsgroups, since its been asked & answered several times.

 

[Klatuu]

Correct. I leave the startup options set to the defaults until I build the
production version and turn them all off.