Photodraw 2000 and Win XP SP2

[Scott J]

After installing Win XP Service Pack 2, my Photodraw 2000 will no longer
load. I noticed before with Win updates that update 890859 caused conflicts.
Thus, I did not install that one. Now, it will not work again. Is there any
fix to allow it to function?

 

[Chris Schatte]

Scott J,
Do you have Version 2?
If so, try uninstalling from add/remove programs then re-install. Should
work fine on Windows XP sp2.

Chris Schatte

 

[Hubert]

PD is finally up and running very nicely, Thank God. I found that when it it
was installed, there was an error message, to send report back to MSoft or
Debug. I clicked debug. After installation. Go start > All Programmes > Right
click on PD > Properties > Click on Compatibility, choose accordingly (I went
for Win 98/Me) > click apply > click OK. > Close all progarmmes > click start

Turn off computer > Click Restart. It should run fine. Iam using XP with

Services Pack 2. Ihope that this helps others. I am using PD Version 1

 

[Chris Segrave]

I have the same problem....

i did the add/remove programs re-install and re-booted my computer, however,
i am still getting the application error.. i sent the error report, but i'm
not expecting this to help me..

any ideas anyone??

R,
Chris

 

[garfield-n-odie]

See http://support.microsoft.com/?kbid=250833 "PhD1: Error
Message: Unable to Start the Application" and
http://support.microsoft.com/?kbid=318924 "Photodraw 2000 Causes
an Error Message in Windows XP".