G
Garnet
When I make changes in my website pages and then save - the page copies
itself to itself...and the code for the content disappears. All I see is
<body bgcolor="#76303A"> over and over again...but no code for the content
that was once there.
If I publish the page...it copies the page over and over again. Eventually -
there is nothing but the shared borders.
I did a Detect and Repair and then recreated my pages that were
duplicated...and after hours of working with the pages...finally published a
clean site.
Is this a problem with FP 2003?
Thanks.
itself to itself...and the code for the content disappears. All I see is
<body bgcolor="#76303A"> over and over again...but no code for the content
that was once there.
If I publish the page...it copies the page over and over again. Eventually -
there is nothing but the shared borders.
I did a Detect and Repair and then recreated my pages that were
duplicated...and after hours of working with the pages...finally published a
clean site.
Is this a problem with FP 2003?
Thanks.