J
JulieD
Hi all
i'm using the snapshot viewer control 9.0 to display a report in a form and
it works fine - until i put the "front-end" onto another machine ... then
the report doesn't display and i have to remove the reference to the viewer
in the code & the control off the form - compact the db and then put it all
back on again (ver 2000) ... i don't know where to start to figure out how
to fix this problem as i need to be able to "roll" out the front-ends (and
updates over time) without having to sit down at each machine and fiddle.
Any ideas
Cheers
JulieD
i'm using the snapshot viewer control 9.0 to display a report in a form and
it works fine - until i put the "front-end" onto another machine ... then
the report doesn't display and i have to remove the reference to the viewer
in the code & the control off the form - compact the db and then put it all
back on again (ver 2000) ... i don't know where to start to figure out how
to fix this problem as i need to be able to "roll" out the front-ends (and
updates over time) without having to sit down at each machine and fiddle.
Any ideas
Cheers
JulieD