table within a section

N

nimita

If I insert a table within a section it adds a line after the table.
This extra line is visible on form preview. How do I avoid this?
I need to show 3 columns in a row within a section that has conditional
formatting.

Thanks.
 
G

Greg Collins [InfoPath MVP]

The extra linebreak is visible in design mode on purpose, so that you can select below the table. This, I know, is not your issue.

However, because of that, you don't always notice (until you preview) that there is an "actual" linebreak there. To eliminate this, I normally select just below the table, then press DELETE a few times, to make sure that there's no space characters or anything, and then press BACKSPACE until the table is selected. This typically ensures that that linebreak is eliminated.

Good luck!
 
Top