S
Slez via AccessMonster.com
I am getting a "Type mismatch" message when I try to run some code via a
command button. I have heard that you can "step through" code line by line
to find where an error is occurring, though I have never done so. Is this
the preferred method to find out where my type mismatch is occurring? How do
I go about doing this?
Thanks in advance!
command button. I have heard that you can "step through" code line by line
to find where an error is occurring, though I have never done so. Is this
the preferred method to find out where my type mismatch is occurring? How do
I go about doing this?
Thanks in advance!