H
Hughesy
I have a db for recording studnets grade in maths. However after getting it
to run perfectly for the last week it has now decided to stop working. It
will show the main switchboard and a secondary switchboard, both of which
operate off a table. When I try to open another from which has two subforms
it just displays the message "file not found".
After reading I have tried to add/subtract libraries but the db keeps
telling me that it cannot perform this operation. I have tried this method by
opening a new module and still no joy.
Do I need to just use a backup and turn it into the design master?
The file not found problem is following through the replicas as well.
to run perfectly for the last week it has now decided to stop working. It
will show the main switchboard and a secondary switchboard, both of which
operate off a table. When I try to open another from which has two subforms
it just displays the message "file not found".
After reading I have tried to add/subtract libraries but the db keeps
telling me that it cannot perform this operation. I have tried this method by
opening a new module and still no joy.
Do I need to just use a backup and turn it into the design master?
The file not found problem is following through the replicas as well.