Using Dragon NaturallySpeaking with InfoPath

M

MdSmitty

I currently have Dragon 7.0 Medical Suite and am unsuccessful at running it
with InfoPath, can anyone tell me if version 8 works with InfoPath? If so,
is there any defaults you need to address durning or after set-up/install of
Dragon to make it work with InfoPath?
 
B

Brian Teutsch [MSFT]

One of my teammates has used Dragon 7.3 without issue with InfoPath. I don't
know anything about 8.0. I don't believe there was anything special about
the 7.3 setup. Can you elaborate on what sort of issues you are seeing?

Brian
 
M

mdsmitty

Basically I can use basic voice commands like "tab key" or "move
(direction+number)" but I cannot dictate into any fields, is there any
defaults that need to be changed or do I have to upgrade from 7.0. I am also
trying to confirm that version 8 works before I go buy an upgrade.
Otherwise, I will get the upgrade to 7.3.

Long story short, I am looking for a version that works with InfoPath.
 
M

mdsmitty

Thank you for your help, I figured out my problem. I had to get SP2 from the
Scansoft website. I have no problem dictating in any fields so far and the
basic global commands seem to be working as well. It took a little while to
find the SP on Scansoft's website, they don't have it listed with downloads
and if it was it wasn't well advertised. I just stumbled across it in one of
the Knowedge Base articals. Thanks again for your help, have a good day.

Mike
 
Top