A
Anne
Often when there is an error that is not disclosed in the error list and
when debugging in office the functionality stops working. Per the
"Connect.vb" module you are told to do the following to reset the settings.
This does not make sense as the option is not available. Can someone
enlighten me on how to correct the issue. The only way I have manged to get
this to work again is to create the project from scracth. A waste of time a
very frustrating. I must be missing something. Please help.
#Region " Read me for Add-in installation and setup information. "
' When run, the Add-in wizard prepared the registry for the Add-in.
' At a later time, if the Add-in becomes unavailable for reasons such as:
' 1) You moved this project to a computer other than which is was originally
created on.
' 2) You chose 'Yes' when presented with a message asking if you wish to
remove the Add-in.
' 3) Registry corruption.
' you will need to re-register the Add-in by building the $SAFEOBJNAME$Setup
project,
' right click the project in the Solution Explorer, then choose install.
#End Region
Thanks in advacne
when debugging in office the functionality stops working. Per the
"Connect.vb" module you are told to do the following to reset the settings.
This does not make sense as the option is not available. Can someone
enlighten me on how to correct the issue. The only way I have manged to get
this to work again is to create the project from scracth. A waste of time a
very frustrating. I must be missing something. Please help.
#Region " Read me for Add-in installation and setup information. "
' When run, the Add-in wizard prepared the registry for the Add-in.
' At a later time, if the Add-in becomes unavailable for reasons such as:
' 1) You moved this project to a computer other than which is was originally
created on.
' 2) You chose 'Yes' when presented with a message asking if you wish to
remove the Add-in.
' 3) Registry corruption.
' you will need to re-register the Add-in by building the $SAFEOBJNAME$Setup
project,
' right click the project in the Solution Explorer, then choose install.
#End Region
Thanks in advacne