3 Hole Punch

[Jason]

Is there a was I can see where my three hole punch is going to be placed? In a brochure that I am doing I don't want some items to be right in line of my punch holes?

 

[Mary Sauer]

Strike a guideline where the holes will be, don't create anything beyond the
guideline. Normally it will be about a half inch, but I'd measure if I were you.

--
Mary Sauer MS MVP
http://office.microsoft.com/clipart/
http://www.mvps.org/msauer/getting_started.htm

Is there a was I can see where my three hole punch is going to be placed? In a

brochure that I am doing I don't want some items to be right in line of my punch
holes?

 

[Budget Print Center]

simple solution:
punch a piece of paper with your tool, measure to the innermost edge of the
hole. set your left & right magins to be beyond that point... shoul do the
trick

--
"Display tolerance & kindness to those with less
knowledge than you because there is ALWAYS
someone with more"

Is there a was I can see where my three hole punch is going to be placed?

In a brochure that I am doing I don't want some items to be right in line of
my punch holes?

 

[°°°MS°Publisher°°°]

Just go to the Office Depot/Office Works/Viking and buy pre-punched paper,
and print on that. It is only about 35c a ream dearer than the plain paper.
Beats the hell out of punching it yourself.

--
The US should free all those
illegally held prisoners they are
torturing, abusing and denying
human rights being held at
Guantanamo Bay.

 

[Dave Dahle]

Is there a was I can see where my three hole punch is going to be placed?

In a brochure that I am doing I don't want some items to be right in line of
my punch holes?

I used a "brute force" solution when I designed a catalog - moved both sets
of guidelines to the right and then designed the catalog pages with the
modified template.

Dave