Full chart view?

[Doug]

When I have the verticle axis set to automatic on the Min & Max range it
usually shows a huge distance on the chart because it generally defaults to
0. If the data is 55-100, the chart will start at 0 at the bottom and the
55-100 will be toward the top scrunching the data. Seems like it should size
up the data to best fit everything when on the auto setting. I don't want to
use a fixed setting because if the data changes then I run into a similar
problem. Is there a way to either change the default settings so the charts
will automatically size themselves, or something else I can do to make this
work for me?

 

[Doug]

Were do I need to put the macro? I tried placing it in the workbook and in
the sheet view code, but doesn't do anything. What am I doing wrong?

 

[Doug]

I have a volume-Open-High-Low-Close chart that I am using this on and it made
the volume extend to the top of the chart, but the price pattern didn't move?
Any more helpful suggestions?

 

[Doug]

I tried this and works fine accept it changes the primary values. Is it
possible to have this change the secondary values instead?

 

[ck13]

You will need to amend the VBA. I am not strong in this so you might need to
post your questions. This discussion group is going to close on 1st June. So
i strongly advise you not to post your question here. post it in this forum
instead. http://answers.microsoft.com/en-us/office/default.aspx#tab=1

This is where I managed to get help from others to amend the VBA i gave you
to include secondary axis.

 

[Doug]

Thanks for your help

You will need to amend the VBA. I am not strong in this so you might need to
post your questions. This discussion group is going to close on 1st June. So
i strongly advise you not to post your question here. post it in this forum
instead. http://answers.microsoft.com/en-us/office/default.aspx#tab=1

This is where I managed to get help from others to amend the VBA i gave you
to include secondary axis.