M
Milton
After making a keyable(Ctrl. T) B&W picture of a sun
using publisher 2000. The 12 lines the suns rays & the
base line for bottom printed ok. But when I made the half
oval from "custom shapes", this is the only part of the
picture that would not print. I also noticed that if I
zoom in over 110% the oval will disappear in my publisher
window.
I cannot use the regular oval because I have to put a
box on the bottom half of the oval to cut it off to make
it like the sun is setting. Once you put a box to cover it
up the bottom half of the oval to make it like a sun is
setting you cannot make the whole picture keyable to on a
web page (you end up with a white box below the sun on
your web page not keyable).
The oval is at 1 point in width, I have tried
increase the line width of the oval with no luck...the
oval will disappear totally at any zoomed incraments.
Any Ideas?
Milton
using publisher 2000. The 12 lines the suns rays & the
base line for bottom printed ok. But when I made the half
oval from "custom shapes", this is the only part of the
picture that would not print. I also noticed that if I
zoom in over 110% the oval will disappear in my publisher
window.
I cannot use the regular oval because I have to put a
box on the bottom half of the oval to cut it off to make
it like the sun is setting. Once you put a box to cover it
up the bottom half of the oval to make it like a sun is
setting you cannot make the whole picture keyable to on a
web page (you end up with a white box below the sun on
your web page not keyable).
The oval is at 1 point in width, I have tried
increase the line width of the oval with no luck...the
oval will disappear totally at any zoomed incraments.
Any Ideas?
Milton