L
LCalaway
I have created a report where the data from one record will span two pages,
portrait. The report needs to be printed back to back (duplexed.) Side 1
of "Page 1" should be blank. Side 2 of "Page 1" will have the left hand
portion of the report above and Side 1 of "Page 2" will have the right hand
side of the report. It will look just like an 8-1/2 x 11 open book where
you would be seeing page 2 on the left and page 3 on the right
The paper size that i am using is 8-1/2 x 11. When looking at the final
report, the page size will be 17 x 11.
I have formatted the report as a single report a little less than 17" wide
and request that it prints on letter sized paper in portrait mode.
How can this be accomplished so that my data lines up correctly.
Thank you
LCalaway
portrait. The report needs to be printed back to back (duplexed.) Side 1
of "Page 1" should be blank. Side 2 of "Page 1" will have the left hand
portion of the report above and Side 1 of "Page 2" will have the right hand
side of the report. It will look just like an 8-1/2 x 11 open book where
you would be seeing page 2 on the left and page 3 on the right
The paper size that i am using is 8-1/2 x 11. When looking at the final
report, the page size will be 17 x 11.
I have formatted the report as a single report a little less than 17" wide
and request that it prints on letter sized paper in portrait mode.
How can this be accomplished so that my data lines up correctly.
Thank you
LCalaway