B
Barry Milliken
Visio 5 had a nice Macro for entering a set of propert lines with bearings
and lengths.
This is ommited from Visio 2002. Instead there is just a shape in the
annotations stencil for a single property line.
This would be OK except there is no way to enter the required bearing in
degrees, minutes and seconds with compass directions (N S E or W)
Instead I have to figure out what the cirresponding angle would be and enter
that.
How dumb is that?
and lengths.
This is ommited from Visio 2002. Instead there is just a shape in the
annotations stencil for a single property line.
This would be OK except there is no way to enter the required bearing in
degrees, minutes and seconds with compass directions (N S E or W)
Instead I have to figure out what the cirresponding angle would be and enter
that.
How dumb is that?