2007: Start all docs in Draft?

[devistated]

Is there some option that I can set so that Word always starts a document
(old or new) in Draft view?

I cannot find such an option. So I am constantly going into the View menu
and choosing Draft for every document that I open to work on.

 

[Doug Robbins - Word MVP]

Right click on the Status Bar (at the bottom of the screen) and check the
"View Shortcuts" item. Then you will just need one click to change the
view.

--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

 

[Graham Mayor]

It should hold the last used view, but you can force any view with a pair of
autorunning macros saved in the normal template eg

Sub AutoNew()
ActiveWindow.View.Type = wdNormalView
End Sub

Sub AutoOpen()
ActiveWindow.View.Type = wdNormalView
End Sub


--
<>>< ><<> ><<> <>>< ><<> <>>< <>><<>
Graham Mayor - Word MVP


<>>< ><<> ><<> <>>< ><<> <>>< <>><<>

 

[Stefan Blom]

Note that you may have to enable the "Allow opening a document in Draft
view" option in Word Options, Advanced category (under the "General"
heading) for this to work properly.

 

[devistated]

This is the answer that I was looking for -- no macros needed. The saves were
not holding the last view.

I had looked in the Word Options, Advanced list but had looked in the
"Display" options and had not looked at the "General" options.

Thank you, Stefan.