S
sboyd
I have an InfoPath Form that is published to a SharePoint 2007 site.
The form has several data connections that are used in drop down boxes
within the form. The form works well as long as I use my local
connections. I can submit from the SharePoint site and pull the form
back up and resubmit with no errors. This is not the case once I
convert the data connections. I can submit the form after creating
the connections but I can't pull the form back up and make any edits.
I'm getting this message.
InfoPath cannot submit the form.
An error occurred while the form was being submitted.
InfoPath cannot connect to the data sources.
Unspecified error.
I've deleted all of the UDCX connections and created them new from
within the form, approved them in SharePoint and then published the
form but I'm still getting the error. Does anyone have any ideas on
why the form works before I convert the data connections but not after
I convert them? Is there a way to trace the steps to see where at
what point the error is occuring?
The form has several data connections that are used in drop down boxes
within the form. The form works well as long as I use my local
connections. I can submit from the SharePoint site and pull the form
back up and resubmit with no errors. This is not the case once I
convert the data connections. I can submit the form after creating
the connections but I can't pull the form back up and make any edits.
I'm getting this message.
InfoPath cannot submit the form.
An error occurred while the form was being submitted.
InfoPath cannot connect to the data sources.
Unspecified error.
I've deleted all of the UDCX connections and created them new from
within the form, approved them in SharePoint and then published the
form but I'm still getting the error. Does anyone have any ideas on
why the form works before I convert the data connections but not after
I convert them? Is there a way to trace the steps to see where at
what point the error is occuring?