Annoying Low memory Error

[MJ]

When I go to save my Publisher file I get a message that says: " Due to low
memory or use of a floppy drive other then the one you started with,
publisher has had to rename your publication ....." There shouldn't be low
memory I recently had a memory upgrade on my computer. I renamed the
publication and it still did the same thing.

Does anyone have any suggestions as to why this is going on. PLEASE!

 

[Mary Sauer]

Hasn't anything to do with RAM, but with virtual memory. See if increasing your
virtual memory helps. What version Publisher?


You receive a "Not enough memory to load graphics or embedded objects" error
message when you open a Publisher publication
http://support.microsoft.com/kb/262855/en-us

 

[MJ]

Thanks for the info. I am using Publisher 2003. I changed my virtual memory
to have the Inital size as 1000 mb and Max size 1500, however I am still
having that same error message comming up .
"Due to low memory or use of a floppy other then the one you started with,
Publisher has had to rename your pulblication (File name). To resume, close
all programs including Publisher; then restart Publisher and open the file.
You may then rename the publication"

I have been using Adobe's "Create Adobe PDF Online" would this have any
affect on this?

Thanks

 

[Mary Sauer]

Do you have Norton?
How to use Office programs with the Norton AntiVirus Office plug-in
http://support.microsoft.com/kb/329820/en-us

Did you install Office 2003 over another version of Office?

Do a detect and repair found under help. You have an issue I haven't seen
before.

You could look through the Adobe troubleshooting support documents.

 

[MJ]

I do have Norton and I followed the steps with no success. I have not
installed publisher 2003 over a previous version however I do have Office
Basic 2003 edition.

I used the Detect and repair and hoped it worked but it didn't. I was on
another computer printing off my publication using Publisher and I received
the same error. My file is about 45 MB in size would that be too large?
Usually there error will come up after printing off something? I save the
changes and they seem to be saved fine.

Does anyone have any suggestions or have heard of this before