Can't Run Macro

Discussion in 'Access Macros' started by JamesJ, May 9, 2010.

  1. JamesJ

    JamesJ Guest

    Access 2007 sp2.
    This Autoexec macro runs fine in my other db but it won't run in another.
    Error 2950.

    I'm simply opening a form. I will eventually add more to this macro but
    can't
    won't do any good unless I can get it to run in the first place.
    In the Trust Center|Macro Settings I have the 'Enable all macros' ticked.
    Again, runs ok in one but not the other. In fact I copied and pasted the
    macro
    from the db where it works ok and the function DOES exist.

    Any ideas?

    James
     
    JamesJ, May 9, 2010
    #1
    1. Advertisements

  2. JamesJ

    broro183 Guest

    broro183, May 9, 2010
    #2
    1. Advertisements

  3. JamesJ

    JamesJ Guest

    Did that. No good

    James
     
    JamesJ, May 9, 2010
    #3
  4. JamesJ

    KARL DEWEY Guest

    Will the macro run manually? I mean open Access and then manually run the
    macro.
     
    KARL DEWEY, May 12, 2010
    #4
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.