G
Glenn
I am creating a Table of Contents in Access according to
the Microsoft Knowledge Base Article 210269. It works
perfectly except for one thing. I have a Report
named "Record of Changes" that at one time was named
just "Changes." I used the Rename tab under file and
renamed the Report. I also changed the name under the
OnPrint Property of the Page Header. Now when I run the
Table of Contents I get "Changes" and "Record of Changes"
listed with the same page number. Where can I look for it
it picking up the original name? Also, I have asked this
before. I am running 42 Reports sequentially to create a
single document. Every time I print the Reports using a
macro opening the Report in Print mode then closing the
Report. I have about 10 Reports that do not print. They
are the same Reports every time. Some are supposed to
pulling data from the same table as the other Reports,
some are just text. Any ideas? And lastly, is there any
way to generate page numbers for Reports dynamically?
Right now they are hard coded, but if a change is made, I
have to change the page numbers manually. Thanks!
the Microsoft Knowledge Base Article 210269. It works
perfectly except for one thing. I have a Report
named "Record of Changes" that at one time was named
just "Changes." I used the Rename tab under file and
renamed the Report. I also changed the name under the
OnPrint Property of the Page Header. Now when I run the
Table of Contents I get "Changes" and "Record of Changes"
listed with the same page number. Where can I look for it
it picking up the original name? Also, I have asked this
before. I am running 42 Reports sequentially to create a
single document. Every time I print the Reports using a
macro opening the Report in Print mode then closing the
Report. I have about 10 Reports that do not print. They
are the same Reports every time. Some are supposed to
pulling data from the same table as the other Reports,
some are just text. Any ideas? And lastly, is there any
way to generate page numbers for Reports dynamically?
Right now they are hard coded, but if a change is made, I
have to change the page numbers manually. Thanks!